Figure 5-34 Removing the access actuator
Step 4 Install the reserved access actuator in the original position and connect the cables.
Step 5 Synchronize the parameters of the access actuator on the ECC800-Pro WebUI.
Step 6 Log in to the ECC800-Pro WebUI and choose System Settings > Access
Management. Set the access permission for the new access actuator according to
the access permission setting for the old access actuator. Then perform
Synchronize Permission.
Step 7 On the ECC800-Pro WebUI, choose Monitoring > System > ECC800 > Controls >
Delete device with communication failure, and click Submit.
Step 8 Log in to the ECC800-Pro WebUI, and edit the plan view by adding new devices.
Step 9 Verify that the aisle access control system is normal.
----End
5.4.3.2 Replacing an Access Control Device
The replacement methods are the same for the
ngerprint and card reader with a
keypad, ngerprint and card reader, and card reader with a keypad.
Impact on the System
The access control system cannot be used.
Preparations
● Tools: ESD wrist strap, ESD gloves, at-head screwdriver, Phillips screwdriver,
labels, marker
● Material: access control device
Procedure
Step 1 Remove screws from the bottom of the access control device and remove the
access control device from the baseplate.
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 86
To Next Page
Loading...
Need help?
General