Figure 5-35 Removing the access control device
Step 2 Remove cables from the old access control device and connect the cables to the
new one.
Step 3 Install the new access control device on the baseplate and secure the device using
screws at the bottom.
Step 4 Log in to the ECC800-Pro WebUI, choose System Settings > Access Management,
and perform the Synchronize Permission operation.
Step 5 Verify that the access control system is normal.
----End
5.4.3.3 Replacing a Button
Context
● The light button and door open button (green) can reset automatically. Both
BOM numbers are 16050101.
● The emergency button (red) needs to be manually reset. Its BOM number is
16050102.
● The door open button, emergency button, and light button are replaced in the
same way.
Impact on the System
The faulty button cannot be used.
Preparations
● Tool: socket wrench
● Material: door open button, emergency button, or light button
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 87
To Next Page
Loading...
Need help?
General