Name: Huawei FusionModule2000
Brand: Huawei
Rating: 5 (1 reviews)

To Next Page

To Previous Page

● Skill requirement: hardware installation engineers

Procedure

Step 1 Disconnect the terminals between the cable delivered with the alarm beacon and

the ECC800-Pro communications cable.

Step 2 Remove the two screws from the alarm beacon and remove the alarm beacon

from the door box.

Figure 5-65 Removing the alarm beacon

Step 3 Route the cable of the new alarm beacon through the cable hole in the right door

box and interconnect the cable with the communications cable on the ECC800-Pro.

Step 4 Secure the new alarm beacon to the right door box using two M3x16 recessed pan

head screws.

Step 5 Simulate a smoky environment under the smoke detector, verify that the alarm

beacon works properly, and then clear the alarm.

----End

5.4.14 Replacing a UIM20A expansion module

Prerequisites

● Tools: Phillips screwdriver, label, marker

● Material: UIM20A expansion module

Procedure

Step 1 Label each cable based on the corresponding ports on the UIM20A expansion

module.

Step 2 Disconnect cables from the UIM20A expansion module.

Step 3 Unscrew the mounting ears from the two sides of the UIM20A expansion module,

and remove the UIM20A expansion module.

FusionModule2000 Smart Modular Data Center

Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement

Huawei FusionModule2000 Maintenance Guide

Other manuals for Huawei FusionModule2000