● If the iBOX is damaged, hold down the networking switches on all the iBATs
managed by the iBOX to clear present network parameters.
● If the iBOX is not damaged, hold down the iBOX networking switch to clear
present network parameters.
Step 2 Disconnect cables from the iBOX and label the cables.
1. Disconnect the cable from the PoE port.
2. Disconnect the cable (if there is any) from the COM port.
3. Disconnect the cable (if there is any) from the BCB port.
4. Disconnect the cable from the HALL current monitoring port.
Figure 5-49 Disconnecting cables from the iBOX
Step 3 Remove the iBOX.
Figure 5-50 Removing an iBOX (from a battery cabinet)
Figure 5-51 Removing an iBOX (from a battery rack)
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 98
To Next Page
Loading...
