Huawei FusionModule2000 Maintenance Guide

Item Method Expected Result Troubleshooting
Air lter Visual
inspection
The air lter is clean
and not blocked.
Remove and clean
the air lter.
(Cleaning with
water is
recommended.)
Visual
inspection
Check that the air
lter is not
damaged or
distorted.
Replace the air
lter.
Compressor Visual
inspection
Check that the
compressor is
secured.
Tighten screws if
the compressor is
not secured.
Visual
inspection
Check that the
compressor service
valve has no oil
stains.
Clean up the oil
stains.
Listen to the
compressor
operating
sound.
Check that the
compressor does
not generate
abnormal sound
during operation.
Replace the
compressor.
Connecting pipes Visual
inspection
Check that the
refrigerant pipe
does not leak or
corrode, and is
properly wrapped
with thermal
insulation foam.
Repair the leakage
points and rewrap
thermal insulation
foam.
Visual
inspection
Check that the
refrigerant pipe
support is secure
and intact.
Replace the support
and secure it again.
Indoor fan Visual
inspection
Check that the
indoor fan guard is
not misshapen.
Repair or replace
the fan guard if it is
misshapen.
Visual
inspection
Check that the
indoor fan blades
are intact.
Replace the fan
assembly.
Check the
running
sound of the
indoor fan.
Check that the
operating indoor
fan generates no
abnormal noise.
Replace the fan
assembly.
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 3 Routine Maintenance
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 25

Huawei FusionModule2000 Specifications

General

Brand	Huawei
Model	FusionModule2000
Category	Storage
Language	English