Figure 5-37 Components of a sliding door magnetic lock
(1) Magnetic lock fastener (2) Magnetic lock
(3) Magnet (4) Magnet fastener
Impact on the System
The access control function of the sliding door is unavailable.
Preparations
● Tool: Phillips screwdriver
● Material: magnetic lock
Procedure
Step 1 Remove cables from the magnetic lock and label the cables.
Step 2 Remove the magnetic lock to be replaced.
Step 3 Secure the magnet to the magnet fastener using the screws and washers available
in the
tting bag of the sliding door magnetic lock, as shown by (1) in Figure
5-38.
Step 4 Take out the magnetic lock and disassemble it, and keep the two screws removed,
as shown by (2) in Figure 5-38.
Step 5 Use the screws removed in the previous step to secure the disassembled magnetic
lock to the magnetic lock fastener, as shown by (3) in Figure 5-38.
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 89
To Next Page
Loading...
