Huawei iSitePower-M MAP05A1 - Page 76

Parameters Settings
Figure 6-21 Setting basic parameters
Table 6-10 Basic parameters
Parameter
Description
Output Voltage Set the output voltage and output frequency based on the
local power grid standards.
Output Frequency
Bypass Input
Overvoltage Limit
Set the bypass input overvoltage and undervoltage
protection thresholds. When the bypass input voltage
reaches the preset value, the system stops output
immediately and reports a bypass module protection
alarm.
Bypass Input
Undervoltage Limit
Operating Mode Maximize PV Consumption: PV power is preferentially
used for loads.
Maximize Power Backup: The mains is preferentially used
to supply power to loads. At the same time, the mains and
PV system charge the ESSs until the ESSs are fully charged.
Backup Power
SOC(%)
This parameter is available only when Operating Mode is
set to Maximize PV Consumption.
Mains/Genset
Detection Port
Select a mains/genset detection port.
Mains Outage Dry
Contact Status
Set the mains outage dry contact status.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 6 Application Scenarios
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 67