4.7.8 How to Enable a Humidity and Temperature Sensor
Context
● A humidity and temperature sensor needs to be enabled after it is installed in
an aisle.
● To enable a sensor, log in as the Admin or Engineer user.
● This section describes how to enable sensors 1 and 2 in cold aisles.
Procedure
Step 1 On the home screen, choose Settings > System Settings > T/H Sensor.
Step 2 Set the value following Cold-aisle sensor 1 and Cold-aisle sensor 2 to Enable, as
shown in Figure 4-44.
Figure 4-44 Enabling a humidity and temperature sensor
----End
4.7.9 How to Check Teamwork Control Information
Procedure
Step 1 On the home screen, choose
> . The teamwork control information is
displayed, as shown in Figure 4-45.
Figure 4-45 Teamwork control information screen
NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm Width) 4 ACC Introduction
Issue 17 (2020-10-22) Copyright © Huawei Technologies Co., Ltd. 128
To Next Page
Loading...
