Figure 4-48 Changing the password
The new password must meet complexity requirements. When you are changing the
password, you can press Ctrl + C to stop this operation.
----End
4.7.12 Rectifying Faults of the E-label Identication Board
Context
If strong electromagnetic interference exists, the E-label identication board is
abnormal, or the E-label
identication board is not properly connected, an
exception may occur during E-label identication.
● If the information shown in Figure 4-49 is displayed on the controller LCD,
the smart cooling product can run properly. To remove this tip, perform Step
1.
Figure 4-49 Message 1
NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm Width) 4 ACC Introduction
Issue 17 (2020-10-22) Copyright © Huawei Technologies Co., Ltd. 132