4.11.4 Checking the Configuration
After OSPF features are configured to improve the stability of an OSPF network, you can check
GTSM statistics and brief statistics.
Prerequisites
The configurations for Improving Security of an OSPF Network are complete.
Procedure
l Run the display gtsm statistics all command to check the GTSM statistics.
l Run the display ospf [ process-id ] request-queue [ interface-type interface-number ]
[neighbor-id ] command to check the OSPF request queue.
l Run the display ospf [ process-id ] retrans-queue [ interface-type interface-number ]
[ neighbor-id ] command to check the OSPF retransmission queue.
l Run the display ospf [ process-id ] error [ lsa ] or display ospf error [ packet
[ number ] ] command to check the OSPF error information.
----End
4.12 Configuring the Network Management Function of
OSPF
OSPF supports the network management function. You can bind the OSPF MIB to a certain
OSPF process, and configure the trap function and log function.
4.12.1 Establishing the Configuration Task
Before configuring the network management function for OSPF, familiarize yourself with the
applicable environment, complete pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
OSPF supports the network management function. You can bind OSPF MIB and a certain OSPF
process. In addition, OSPF also supports the trap function and the log function.
Pre-configuration Tasks
Before configuring the network management function of OSPF, complete the following tasks:
l Configuring IP addresses for interfaces to make neighboring nodes reachable
l Configuring Basic OSPF Functions
Data Preparation
To configuring the network management function of OSPF, you need the following data.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 4 OSPF Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
132
To Next Page
Loading...
Need help?
General
