Huawei S1720 Series Configuration Guide

No. Data
2 LSP parameters
6.4.2 Configuring IS-IS Timers for Packets
This part describes how to set the intervals for sending Hello packets, Complete Sequence
Number PDUs (CSNPs), and Link State PDUs (LSPs).
Context
Do as follows on the switch that runs IS-IS.
Procedure
l Configuring the Interval for Sending Hello Packets
1. Run:
system-view
The system view is displayed.
2. Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
3. Run:
isis timer hello hello-interval [ level-1 | level-2 ]
The interval for sending the Hello packets is set on an interface.
On a broadcast link, there are Level-1 and Level-2 Hello packets. For different types
of packets, you can set different intervals. If no level is specified, both the Level-1
timer and Level-2 timer are configured. On a P2P link, there are only one type of Hello
packets. Thus, neither level-1 nor level-2 is required.
NOTE
Parameters level-1 and level-2 are configured only on a broadcast interface.
l Configuring the Invalid Number of Hello Packets
1. Run:
system-view
The system view is displayed.
2. Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
3. Run:
isis timer holding-multiplier number [ level-1 | level-2 ]
The invalid number of Hello packets is set.
If no level is specified, both the Level-1 timer and Level-2 timer are configured.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
254

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm