2.5.5 Checking the Configuration
After the function of controlling the advertising of RIP routing information is successfully
configured, you can view the current running status, configuration, and routing information
about RIP.
Prerequisites
The configurations for controlling the advertising of RIP routing information are complete.
Procedure
l Run the display rip [ process-id | vpn-instance vpn-instance-name ] command to check
the running status and configuration of RIP.
l Run the display rip process-id database command to check all activated routes in the RIP
database.
l Run the display rip process-id route command to check all the RIP routes that are learned
from other switchs..
----End
2.6 Controlling the Receiving of RIP Routing Information
To meet the requirements of complex networks, accurately controlling the receiving of RIP
routing information is essential.
2.6.1 Establishing the Configuration Task
You can obtain RIP routing information by receiving Update packets and host routes.
Applicable Environment
In practice, to meet the requirements of a complex network, it is required to control the receiving
of RIP routing information accurately. After performing configuration procedures in this section,
you can:
l Disable an interface from receiving RIP Update packets.
l Filter the received routing information.
l Import external routes from various routing protocols and filter the imported routes.
Pre-configuration Tasks
Before configuring a switch to control the receiving of RIP routing information, complete the
following tasks:
l Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at
the network layer
l Configuring Basic RIP Functions
Data Preparation
To control the receiving of RIP routing information, you need the following data.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
36
To Next Page
Loading...
Need help?
General
