Huawei S1720 Series Configuration Guide

The RIP process is enabled and the RIP view is displayed.
Step 3 Run:
network network-address
RIP is enabled in the specified network segment.
network-address specifies the address of a natural network segment.
NOTE
An interface can be associated with only one RIP process.
If any network segment in which an interface configured with multiple sub-interface IP addresses resides
is associated with a RIP process, the interface cannot be associated with any other RIP processes.
----End
2.3.4 Configuring RIP Version Number
RIP versions include RIPv1 and RIPv2. The two versions have different functions.
Context
Do as follows on the RIP switch.
Procedure
l Configuring the Global RIP Version Number
1. Run:
system-view
The system view is displayed.
2. Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
3. Run:
version { 1 | 2 }
The global RIP version number is specified.
l Configuring the RIP Version Number for an Interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface vlanif interface-number
The interface view is displayed.
3. Run:
rip version { 1 | 2 [ broadcast | multicast ] }
The RIP version number of the packets received by the interface is specified.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm