Run the display bgp peer verbose and the display bgp group commands. You can find
the configured maximum valid TTL value and GTSM being enabled on a BGP4+ peer or
peer group.
----End
8.14 Maintaining BGP4+
Maintaining BGP4+ involves resetting a BGP4+ connection and clearing BGP4+ statistics.
8.14.1 Resetting BGP4+ Connections
This section describes how to clear the statistics of BGP4+ accounting, flapped routes, and
suppressed routes.
Context
CAUTION
The peer relationship is broken after you reset the BGP4+ connections with the reset bgp
ipv6 command. Exercise caution when running this command.
After the BGP4+ configuration changes, reset the BGP4+ connections to validate the
modification.
To reset the BGP4+ connections, run the following reset command in the user view.
Procedure
l To validate the new configuration, run the reset bgp ipv6 all command in the user view to
reset all the BGP4+ connections.
l To validate the new configuration, run the reset bgp ipv6 as-number command in the user
view to reset the BGP+4 connections between the peers in a specified AS.
l To validate the new configuration, run the reset bgp ipv6 { ipv4-address | ipv6-address |
group group-name } command in the user view to reset the BGP+4 connections with the
specified peer (or peer group).
l To validate the new configuration, run the reset bgp ipv6 external command in the user
view to reset the external BGP4+ connections.
l To validate the new configuration, run the reset bgp ipv6 internal command in the user
view to reset the internal BGP4+ connections.
----End
8.14.2 Clearing BGP4+ Statistics
Devices can generate debugging information after the debugging of a module is enabled in the
user view. Debugging information shows the contents of the packets sent or received by the
debugged module.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 8 BGP4+ Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
541
To Next Page
Loading...
Need help?
General
