EasyManuals Logo

Huawei S1720 Series Configuration Guide

Huawei S1720 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #289 background imageLoading...
Page #289 background image
3. Configuring IS-IS to Import External Routes
If you want to set the cost for the imported route, you can run the import-route
protocol [ process-id ] [ cost-type { external | internal } | cost cost | tag tag |
route-policy route-policy-name | [ level-1 | level-2 | level-1-2 ] ]
*
command to
import the external routes.
If you want to keep the original cost for the imported route, you can run the import-
route { { rip | isis | ospf } [ process-id ] | direct | unr | bgp } inherit-cost [ tag
tag | route-policy route-policy-name | [ level-1 | level-2 | level-1-2 ] ]
*
command
to import the external routes. When configuring IS-IS to retain the original cost
value of the imported route, the source routes cannot be static.
NOTE
IS-IS will advertise all imported external routes to the IS-IS areas by default.
If only some imported external routes need to be advertised, run the filter-policy export
command to set a filtering policy.
l (Optional) Configure IS-IS to advertise some external routes to the IS-IS areas.
1. Run:
system-view
The system view is displayed.
2. Run:
isis [ process-id ]
The IS-IS view is displayed.
3. Run:
filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-name
| route-policy route-policy-name } export [ protocol [ process-id ] ]
IS-IS is configured to advertise specified external routes to the IS-IS areas.
NOTE
After this command is run, only external routes that meet the specified conditions can be
advertised to the IS-IS areas.
----End
6.7.5 Checking the Configuration
After IS-IS is enabled to import routes from other protocols, run the following commands to
verify that the configurations are correct.
Procedure
l Run the display isis lsdb [ { level-1 | level-2 } | verbose | { local | lsp-id | is-name symbolic-
name } ]
*
[ process-id | vpn-instance vpn-instance-name ] command to check IS-IS LSDB
information.
l Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ]
[ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ]
*
command to check IS-
IS routing information.
l Run the display ip routing-table ip-prefix ip-prefix-name [ verbose ] command to check
the IP routing table.
----End
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
270

Table of Contents

Other manuals for Huawei S1720 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S1720 Series and is the answer not in the manual?

Huawei S1720 Series Specifications

General IconGeneral
Operating Humidity5% to 95% (non-condensing)
Uplink Ports4 x GE combo ports
VLANs4094
Power SupplyAC 100-240V, 50/60Hz
Layer 2 FeaturesVLAN
Layer 3 FeaturesStatic routing
ManagementSNMP
Operating Temperature0°C to 45°C
Storage Temperature-40°C to +70°C
Dimensions (W x D x H)442 mm x 220 mm x 43.6 mm

Related product manuals