Huawei S1720 Series Configuration Guide

3.8.1 Clearing RIPng
This section describes how to clear statistics about RIPng counters.
Context
CAUTION
RIPng information cannot be restored after it is cleared. Exercise caution when running the
commands.
To clear RIPng information, run the following reset command in the user view.
Procedure
l Run the reset ripng process-id statistics interface { all | interface-type interface-
number [ neighbor neighbor-ip-address ] } command in the user view to clear statistics
about the counter that is maintained by a specified RIPng process.
----End
3.9 Configuration Examples
This section provides a configuration example of RIPng.
3.9.1 Example for Configuring RIPng to Filter the Received Routes
Networking Requirements
As shown in Figure 3-1, the prefix length of all the IPv6 addresses is 64 bits. In addition, the
VLANIF interfaces between the neighboring Switches are assigned IPv6 link-local addresses.
All the Switches must learn IPv6 routing information on the network through RIPng. Switch B
should filter the routes received from Switch C (3::/64). That is, Switch B does not add the routes
to its own routing table or advertise the routes to Switch A.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm