EasyManuals Logo

Huawei S1720 Series Configuration Guide

Huawei S1720 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #218 background imageLoading...
Page #218 background image
Follow-up Procedure
To connect switches to an NSSA, you need to run the nssa command to configure NSSA
attributes for the area to which the switches belong.
The area may be updated after NSSA attributes are configured or deleted. Thus, the NSSA
attributes can be re-configured or deleted only after the last update of NSSA attributes is
complete.
5.6.3 Checking the Configuration
After OSPFv3 NSSAs are configured, you can check OSPFv3 routing table information.
Prerequisites
The configurations for OSPFv3 NSSAs are complete.
Procedure
l Run the display ospfv3 area command to check information about OSPFv3 areas.
l Run the commands as follow to check the OSPFv3 routing table.
display ospfv3 [ process-id ] routing uninstalled
display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics
[ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes |
nssa-routes ]
----End
5.7 Configuring OSPFv3 Route Attributes
By setting OSPFv3 route attributes, you can change OSPFv3 routing policies to meet the
requirements of complex networks.
5.7.1 Establishing the Configuration Task
Before configuring OSPFv3 route attributes, familiarize yourself with the applicable
environment, complete pre-configuration tasks, and obtain the required data. This can help you
complete the configuration task quickly and accurately.
Applicable Environment
In actual applications, to meet the requirements of a complicated networking environment, you
can change OSPFv3 routing policies by configuring OSPFv3 route attributes. Through the
following procedures, you can:
l Set the cost on the OSPFv3 interface.
l Configure load balancing among equal-cost routes.
Pre-configuration Tasks
Before configuring OSPFv3 route attributes, complete the following tasks:
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
199

Table of Contents

Other manuals for Huawei S1720 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S1720 Series and is the answer not in the manual?

Huawei S1720 Series Specifications

General IconGeneral
Operating Humidity5% to 95% (non-condensing)
Uplink Ports4 x GE combo ports
VLANs4094
Power SupplyAC 100-240V, 50/60Hz
Layer 2 FeaturesVLAN
Layer 3 FeaturesStatic routing
ManagementSNMP
Operating Temperature0°C to 45°C
Storage Temperature-40°C to +70°C
Dimensions (W x D x H)442 mm x 220 mm x 43.6 mm

Related product manuals