8.10.5 Checking the Configuration
After a BGP4+ peer group is configured, you can check detailed information about the BGP4+
peer and information about the BGP4+ peer group.
Prerequisites
The configurations for a BGP4+ peer group are complete.
Procedure
l Run the display bgp ipv6 group [ group-name ] command to check information about the
IPv6 peer group.
----End
8.11 Configuring a BGP4+ Route Reflector
By configuring a BGP4+ route reflector, you can solve the problem of establishing fully meshed
connections between multiple IBGP peers.
8.11.1 Establishing the Configuration Task
Before configuring a BGP4+ route reflector, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
To ensure the connectivity between IBGP peers inside an AS, you need to establish full-meshed
IBGP peers. When there are many IBGP peers, establishing a full-meshed network costs a lot.
The route reflector or the confederation can be used to solve this problem.
Pre-configuration Tasks
Before configuring a BGP4+ route reflector, complete the following task:
l 8.3 Configuring Basic BGP4+ Functions
Data Preparation
To configure a BGP4+ route reflector, you need the following data.
No.
Data
1 Roles of each switch (reflector, client, and non-client)
8.11.2 Configuring a Route Reflector and Specifying Clients
A route reflector and clients need to be configured in a specified address family.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 8 BGP4+ Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
533
To Next Page
Loading...
Need help?
General
