Huawei S1720 Series Configuration Guide

3.3.2 Enabling RIPng and Entering the RIPng View
Creating RIPng processes is the prerequisite to performing RIPng configurations. When creating
RIPng processes, you can also enter the RIPng view to perform configurations.
Context
Do as follows on the switch to be enabled with RIPng:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ripng [ process-id ]
The RIPng process is enabled and the RIPng view is displayed.
When only one RIPng process runs, process-id does not need to be specified. That is, process-
id defaults to 1.
After the RIPng process is cancelled, the ripng process-id enable command needs to be
reconfigured on an interface.
----End
3.3.3 Enabling RIPng in the VLANIF Interface View
After an interface is associated with a RIPng process, routing information on this interface can
be exchanged through RIPng.
Context
Do as follows on the switch to be enabled with RIPng:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
The interface is at the network side of the switch. That is, the switch is connected to other devices
through this interface. To enable the switch to learn routes to the network segment where the
interface resides, ensure that the link status of the interface is Up.
Step 3 Run:
ripng process-id enable
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm