Huawei S1720 Series Configuration Guide

1.4 Configuring an IPv6 Static Route
On an IPv6 network, you can accurately control route selection by configuring IPv6 static routes.
1.4.1 Establishing the Configuration Task
Before configuring an IPv6 static route, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the data required for the configuration. This
will help you complete the configuration task quickly and accurately.
Applicable Environment
On a small IPv6 network, you can implement network interconnection by configuring IPv6 static
routes. Compared with using dynamic routes, using static routes saves the bandwidth.
Pre-configuration Tasks
Before configuring an IPv6 static route, complete the following task:
l Configuring link layer protocol parameters and IP addresses for interfaces to ensure that
the link layer protocol status of the interfaces is Up
Data Preparation
To configure an IPv6 static route, you need the following data.
No.
Data
1 Destination address and mask
2 Outbound interface or next-hop IPv6 address
3 Preference of the IPv6 static route
1.4.2 Configuring an IPv6 Static Route on the Public Network
When configuring an IPv6 static route, you need to correctly configure its destination address,
outbound interface, and next hop.
Context
Do as follows on the switch to be configured with static routes:
Procedure
Step 1 Run:
system-view
The system view is displayed.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 1 IP Static Route Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm