EasyManuals Logo

Huawei S1720 Series Configuration Guide

Huawei S1720 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
No. Data
1 ACL used to filter the routing information
2.6.2 Disabling an Interface from Receiving RIP Update Packets
Disabling interfaces from receiving Update packets is a method of preventing routing loops.
Context
By default, an interface is allowed to receive RIP Update packets.
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
Step 3 Run:
undo rip input
The interface is disabled from receiving RIP Update packets.
----End
2.6.3 Disabling RIP from Receiving Host Routes
When you disable RIP from receiving host routes on a router, the router rejects to receive host
routes. This prevents the router from receiving a large number of unnecessary routes and thus
avoiding wasting network resources.
Context
In certain situations, a switch may receive a large number of host routes from the same network
segment. These routes are not required in route addressing, but consume many network
resources. You can configure the switch to refuse to accept host routes by disabling RIP from
accepting host routes.
By default, host routes are added to the routing table.
Do as follows on the RIP switch:
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
37

Table of Contents

Other manuals for Huawei S1720 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S1720 Series and is the answer not in the manual?

Huawei S1720 Series Specifications

General IconGeneral
Operating Humidity5% to 95% (non-condensing)
Uplink Ports4 x GE combo ports
VLANs4094
Power SupplyAC 100-240V, 50/60Hz
Layer 2 FeaturesVLAN
Layer 3 FeaturesStatic routing
ManagementSNMP
Operating Temperature0°C to 45°C
Storage Temperature-40°C to +70°C
Dimensions (W x D x H)442 mm x 220 mm x 43.6 mm

Related product manuals