The interface view is displayed.
Step 3 Run:
ripng pkt-transmit { interval interval | number pkt-count }
*
The interval for sending RIPng Update packets and the maximum number of packets sent each
time are set on the specified interface.
----End
3.7.4 Configuring Split Horizon and Poison Reverse
You can configure split horizon and poison reverse to prevent routing loops.
Context
Split horizon is a method of preventing routing loops by preventing the switch from advertising
a route back onto the interface from which the route is learned. On NBMA networks such as FR
networks and X.25 networks, split horizon is disabled by default.
Poison reverse is another method of preventing routing loops by enabling the switch to advertise
a route as unreachable back through the interface from which the route is learned.
If both split horizon and poison reverse are configured, only poison reverse takes effect.
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The interface view is displayed.
Step 3 Run the following command as required:
l Run:
ripng split-horizon
Split horizon is enabled.
l Run:
ripng poison-reverse
Poison reverse is enabled.
----End
3.7.5 Enabling the Zero Field Check for RIPng Packets
In a RIPng packet, there are certain fields whose values must be 0. These fields are called zero
fields. If the values of these zero fields in some RIPng packets are not 0s, these RIPng packets
are ignored.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
74
To Next Page
Loading...
Need help?
General
