Huawei S1720 Series Configuration Guide

Context
Do as follows on the RIP switch:
Procedure
l Configuration in a RIP Process (with a High Priority)
1. Run:
system-view
The system view is displayed.
2. Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
3. Run one of the following commands depending on the site requirements.
Run:
silent-interface all
All interfaces are disabled from sending Update packets.
Run:
silent-interface interface-type interface-number
An interface is disabled from sending Update packets.
You can set an interface to silent so that it only receives Update packets to update its
routing table. The silent-interface command takes precedence over the rip output
command in the interface view.
By default, an interface can receive and send Update packets.
l Configuration in the Interface View (with a Low Priority)
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
3. Run:
undo rip output
The interface is disabled from sending RIP Update packets.
By running this command, you can specify whether to send RIP Update packets on
an interface. The silent-interface command takes precedence over the undo rip
output command. By default, an interface is allowed to send RIP Update packets.
----End
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34

Huawei S1720 Series Specifications

General

Operating Humidity	5% to 95% (non-condensing)
Uplink Ports	4 x GE combo ports
VLANs	4094
Power Supply	AC 100-240V, 50/60Hz
Layer 2 Features	VLAN
Layer 3 Features	Static routing
Management	SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to +70°C
Dimensions (W x D x H)	442 mm x 220 mm x 43.6 mm