Huawei SmartAX MA5608T Hardware Description

Pin Assignments
NOTE
"SN" in "Cable and SN" is the print on the cable sheath.
A 75-ohm E1 trunk cable consists of the shield layer and wire.
In the following table, "Rx/Tx Channel" indicates that the transmitting is from the board and the
receiving is to the board.
l R0: receive end of channel 0 E1 signals
l T0: transmit end of channel 0 E1 signals
X1 Pin
Cable and SN Rx/Tx
Channel
X1 Pin Cable and SN Rx/Tx
Channel
38 Shield
layer
1 R0 15 Shield
layer
2 T0
23 Wire 30 Wire
37 Shield
layer
3 R1 14 Shield
layer
4 T1
22 Wire 29 Wire
36 Shield
layer
5 R2 13 Shield
layer
6 T2
21 Wire 28 Wire
35 Shield
layer
7 R3 12 Shield
layer
8 T3
20 Wire 27 Wire
34 Shield
layer
9 R4 11 Shield
layer
10 T4
19 Wire 26 Wire
33 Shield
layer
11 R5 10 Shield
layer
12 T5
18 Wire 25 Wire
32 Shield
layer
13 R6 9 Shield
layer
14 T6
17 Wire 24 Wire
31 Shield
layer
15 R7 8 Shield
layer
16 T7
16 Wire 7 Wire
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Hardware Description
5 Cable
Issue 24 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
892

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE