Husky Altanium Matrix5 User Manual

v 1.0 — February 2020 Altanium Matrix5
226 Install the Dual Touch Monitor
6. Connect the HDMI end of the HDMI-to-DVI Extension cable to the HDMI connector end
of the DisplayPort to HDMI Converter. Refer to Figure 15-40.
7. Route the USB and HDMI-to-DVI Extension cables from the MCU to the location of the
secondary touch monitor. Refer to Figure 15-41.
Figure 15-40 HDMI-to-DVI Extension
WARNING!
The cables should be routed in accordance with local codes. This includes areas free of
debris and liquids and away from sharp edges or objects that can pinch or cut the cable
housing or conductors. The cables should not be bent at a radius less than 4x the outer
diameter of the cables. Ensure that the cables are routed in areas where the ambient
temperature is within a range of -10 °C to 60 °C (14 °F to 140 °F). It is also recommended
that the cables are routed away from other cables, especially those that are high
voltage or high frequency, to minimize signal interference.
Figure 15-41 Route Cables

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English