(CONTINUED)
018 (continued)
IS THE LIST OF INSTALLED DEVICES CORRECT?
Yes No
019
Go to “Checking the Installed Devices List” on
page 334.
If the problem is not corrected, go to “Undetermined
Problem” on page 333.
020
– Run the advanced diagnostics tests.
DID THE TESTS IDENTIFY A FAILURE?
Notes:
1. If the test stops and you cannot continue, replace the
last device being tested.
2. The following table describes the slot information
displayed on the screen. This information is also
displayed during the test of the 3550 Expansion Unit
when the test is successfully completed. “n” can be
any number.
Yes No
021
Go to Step 023.
022
Follow the action described on the screen. If the problem
is not corrected, go to the “Symptom-to-FRU Index” on
page 329.
023
DID THE POST END WITHOUT AN ERROR?
Yes No
024
If you noticed an error symptom or if you received
any POST error codes when the computer
powered-on, go to “Symptom-to-FRU Index” on
page 329.
- or -
If the problem is not corrected, go to “Undetermined
Problem” on page 333.
Slot Number Identified Device
n IBM 3550 Expansion Unit
n+1 Built-in SCSI
n+2 Upper slot
n+3 Lower slot
326 IBM Mobile Systems HMM - Volume 1