Testing the SCSI Subsystem
Note: If a SCSI adapter is installed in an ISA slot, remove
it before running the SCSI diagnostic program.
1. When you select Test SCSI Subsystem on the Main
Menu, the diagnostics program checks the system
configuration for SCSI devices and displays the
following if no SCSI controller is found.
No SCSI found
SCSI Subsystem Diagnostics Utility V1.0
Enter F3=Exit
If a SCSI controller is found, the computer goes on to
initialize the SCSI devices and displays the following.
Scanning Target #n
SCSI Subsystem Diagnostics Utility V1.0
Enter F3=Exit
2. If the initialization fails, the following screen appears.
SCSI Initialization Failed
SCSI Subsystem Diagnostics Utility V1.0
Enter F3=Exit
412 IBM Mobile Systems HMM - Volume 1
To Next Page
Loading...
Need help?
General