Step 154B-7
Have all the cards listed in “Step 154B-4” on page 155 been replaced?
No Go to “Step 154B-2” on page 155.
Yes Go to “Step 154B-8”.
Step 154B-8
Turn off the power.
Step 154B-9
Ensure that the power is off on the base system drawer.
Step 154B-10
Attention: Before replacing the processor backplane, call for support.
Replace the processor backplane at U0.1-P1, if not already replaced..
Step 154B-11
Turn on the power.
Step 154B-12
Did the system stop with the same error code as recorded in “Step 154B-1” on page 155?
No The card just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to ″MAP 0410: Repair Checkout″ in the RS/6000 Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
Yes Go to “Step 154B-13”.
Step 154B-13
Turn off the power.
Step 154B-14
Call for support. This ends the procedure.
156 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
