IBM pSeries 630 6C4 User Manual

Setup Remote IPL (Initial Program Load)
This option allows you to enable and set up the remote startup capability of your system or partition. A list
of NIC (network interface card) adapters in the system displays first. An example of this screen is shown
below:
Attention: In a partitioned system, only those network adapters that have been assigned to the partition
being booted display in the IP Parameters menu. In a full system partition, all network adapters in the
system are listed in the adapter parameters menu.
NIC Adapters
Device Slot Hardware Address
1. 10/100 Mbps Ethernet PCI Adapt Integ: U0.1-P1/E1 00096baeac10
2. IBM 10/100/1000 Base-TX PCI U0.1-P2-I1/E1 0009cbce0fde
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
When an adapter is selected, the network parameters menu displays:
Network Parameters
10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E1
1. IP Parameters
2. Adapter Parameters
3. Ping Test
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Selecting the IP (Internet Protocol) parameters option displays the following menu:
IP Parameters
10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E1
1. Client IP Address [000.000.000.000]
2. Server IP Address [000.000.000.000]
3. Gateway IP Address [000.000.000.000]
4. Subnet Mask [255.255.255.000]
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
410 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide

IBM pSeries 630 6C4 Specifications

General

Brand	IBM
Model	pSeries 630 6C4
Category	Server
Language	English