Procedure Procedure Name and Page Location
System Board (Refer to CEC Backplane)
Rack Hardware “Attaching the Mounting Hardware to the Rack Enclosure” on page 567
VPD Update “System Vital Product Data (VPD) Update Procedure” on page 486
Handling Static-Sensitive Devices
Attention: Electronic boards, diskette drives, and disk drives are sensitive to static electricity discharge.
These devices are wrapped in antistatic bags to prevent this damage.
Take the following precautions:
v If you have an antistatic wrist strap available, use it while handling the device.
v Do not remove the device from the antistatic bag until you are ready to install the device in the system.
v With the device still in its antistatic bag, touch it to a metal frame of the system.
v Grasp cards and boards by the edges. Hold drives by the frame. Avoid touching the solder joints or
pins.
v If you need to lay the device down while it is out of the antistatic bag, lay it on the antistatic bag. Before
picking it up again, touch the antistatic bag and the metal frame of the system at the same time.
v Handle the devices carefully to prevent permanent damage.
Chapter 9. Removal and Replacement Procedures 423
To Next Page
Loading...
Need help?
General