Examples for Using the Generic Sample Modem Configuration Files
The following table contains information to help you determine which modem configuration file to use with
various modems.
Modem Setup Z Setup Z0
(Rare)
Setup F Setup F0 Setup F1
AT&T DataPort 2001
(Ring interrupt only on first
ring)
X
Bocamodem 1440E X
Hayes Smart Modem 300 X
IBM 5841 X
IBM 5843 X
IBM 7851 X
IBM 7852-10 X
IBM 7855 X
USRobotics
36.6K Sportster
X
Zoom V.32 X
Customizing the Modem Configuration Files
You can create your own modem configuration files or modify the samples provided. After you customize
your modem configuration files, you must access them through the Configure Remote Maintenance Policy
Service Aid rather than from the service processor menus.
Note: If you have already set up your serial ports, line speeds, authorizations, and telephone numbers
from the service processor menus, use the service aid to specify your customized modem
configuration files.
If you have not already set up your serial ports, line speeds, authorizations, and telephone numbers
from the service processor menus, use the service aids to set them while you specify your
customized modem configuration files.
To disable Auto-Reliable Mode testing of the remote modem, use the sample modem configuration file
/usr/share/modems/modem_f.cfg as a model that you can modify, as follows:
1. Find the necessary command in your modem manual.
2. Copy the /usr/share/modems/modem_f.cfg file to a new file with a different name (for example,
modem_fx.cfg).
3. In the new file (modem_fx.cfg), change the line Send "ATE0T\r" to Send "ATcccE0T\r" where ccc is
the added command as specified in your modem manual, as follows:
Change the third line of each of the following stanzas:
v condout
v condin
v ripo
4. Save the changes.
Appendix F. Modem Configurations 599
To Next Page
Loading...
Need help?
General