IBM pSeries 630 6C4 User Manual

Table 4. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
2B20 8888 Operating system termination request received Informational message.
2B2x 00EE Description: An exception error has been reported on a global processor
Action: The type of interrupt that caused the exception is specified by the x as follows:
0: Unknown interrupt
1: System reset interrupt (SRI)
2. Machine check interrupt (MCI)
3. Data storage interrupt (DSI)
4. Instruction storage interrupt (ISI)
5. External interrupt (EXI)
6. Alignment interrupt (ALI)
7. Program interrupt (SRI)
8. Floating unavailable interrupt (FUI)
1. Check for system firmware updates. Apply if available.
2. Call service support.
2BA0 0000 Service processor POST failure Replace CEC backplane
Location: U0.1-P1
2BA0 0012 Service processor reports self test failure Replace CEC backplane
Location: U0.1-P1
2BA0 0013 Service processor reports bad NVRAM CRC Refer to the actions for error code 25A8 0xxx.
2BA0 0017 Service processor reports bad or low battery.
1. Replace the battery.
2. Refer to the actions for error code 25A8
0xxx.
2BA0 0021 Open firmware mailbox call to activate attention
LED failed
Call service support.
2BA0 0041 Service processor VPD is corrupted. Replace CEC backplane
Location: U0.1-P1
2BA0 0071 VPD data is corrupted for processor card 1. Replace the processor card
Location: U0.1-P1-C1
2BA0 0073 VPD data is corrupted for processor card 2. Replace the processor card
Location: U0.1-P1-C2
2BA0 0080 Service processor hardware reset request
failure
1. Check for system firmware updates. Apply if
available.
2. Call service support.
Service Processor Error Codes
Attention: Follow the procedure defined in the “Checkpoint and Error Code Index” on page 213. If you
replace FRUs or perform an action and the problem is still not corrected, go to “MAP 1548: Processor
Subsystem Problem Isolation” on page 139 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to ″MAP 0410: Repair Checkout″ in the RS/6000
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Chapter 5. Error Code to FRU Index 249

IBM pSeries 630 6C4 Specifications

General

Brand	IBM
Model	pSeries 630 6C4
Category	Server
Language	English