Model 6C4 Drawer-Release Latch and Brackets
The following procedure covers the removal and replacement of the system’s drawer-release latch.
Drawer-Release Latch Removal
To remove one of the Model 6C4 drawer-release latches, do the following:
1. Open the front rack door and place the system into the service position as described in “Placing the
Model 6C4 into the Service Position” on page 429.
2. Remove the retaining screw located on the side of the release latch.
3. Pull the release latch off the latch bracket post.
1 System Drawer-Release Latch 5 System Drawer-Release Latch
2 System Drawer-Release Latch
Bracket (Right)
6 Retaining Screws
3 Model 6C4 7 Release Latch Retaining Screw
4 System Drawer-Release Latch
Bracket (Left)
8 Latch Bracket Post
Chapter 9. Removal and Replacement Procedures 427
To Next Page
Loading...
