System Power Control Menu
This menu is used to set power control options. Other menus that control boot options are available from
this menu.
SYSTEM POWER CONTROL MENU
1. Enable/Disable Unattended Start Mode:
Currently Enabled
2. Ring Indicate Power-On Menu
3. Reboot/Restart Policy Setup Menu
4. Power-On System
5. Power-Off System
6. Enable/Disable Fast System Boot
Currently Fast Boot
7. Boot Mode Menu
98. Return to Previous Menu
99. Exit from Menus
0>
v Enable/Disable Unattended Start Mode
Use this option to instruct the service processor to restore the power state of the system after a
temporary power failure. Unattended start mode can also be set through the System Management
Services (SMS) menus. This option is intended to be used on systems that require automatic power-on
after a power failure. For more information, see “System Power-On Methods” on page 391.
v Ring Indicate Power-On Menu
RING INDICATE POWER-ON MENU
1. Ring indicate power-on :
Currently Enabled
2. Number of rings:
Currently 3
30. Refresh Modem Settings
98. Return to Previous Menu
Ring indicate power-on is enabled by default on both serial port 1 (S1) and serial port 2 (S2). When ring
indicate power-on is enabled, call-in is disabled.
If ring indicate power-on is enabled and call-in is already enabled, you will be asked to confirm your
choice. Refer to the message displayed on your screen.
If the ring indicate power-on setting is changed, you must select option 30, Refresh Modem Settings to
update the modem settings. If Refresh Modem Settings is selected, and the modem(s) have not been
configured, you will be asked to configure the modems first. See “Call-In/Call-Out Setup Menu” on
page 386 for information on configuring modems.
Option 2 is used to set the number of rings.
372 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General