Word 13 Value Action
A786 xxxx
1. Trace the SPCN cable attached to U0.1-P1/Q5 of the base system drawer back to an
attached I/O drawer connector U0.dd-P1/Q6.
2. Trace the SPCN cable attached to connector U0.dd-P1/Q5 of this I/O drawer back to an
attached I/O drawer connector U0.dd-P1/Q6.
3. Replace the SPCN cable attached to connector U0.dd-P1/Q5 of this I/O drawer.
A787 xxxx
1. Trace the SPCN cable attached to U0.1-P1/Q5 of the base system drawer back to an
attached I/O drawer connector U0.dd-P1/Q6.
2. Replace the SPCN cable attached to connector U0.dd-P1/Q5 of this I/O drawer.
A78F xxxx Replace the SPCN cable attached to U0.1-P1/Q5 of the base system drawer.
Step 154C-4
Turn on the power.
Step 154C-5
Did the system stop with the same error code as recorded in “Step 154C-1” on page 157?
No The SPCN cable just replaced was defective. This ends the procedure. Return the system to its
original configuration. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 Eserver pSeries
Diagnostic Information for Multiple Bus Systems.
Yes If an I/O drawer will not power on, go to “MAP 1522: Cannot Power On the I/O Drawer, Power
Present LED Does Not Come On” on page 114. Otherwise, call service support.
158 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General