EasyManua.ls Logo

IBM pSeries 630 6C4 - Page 206

IBM pSeries 630 6C4
651 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Checkpoint Description Action/
Possible Failing FRU
E550 Begin to initialize RIO interface chip Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
E551 Set up the RIO speed Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
E552 Set up RIO interface chip registers Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
E553 Set up the RIO interface chip base address Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
E554 Set up more RIO interface chip registers Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
E555 Set up the RIO interface chip RIO link Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
186 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide

Table of Contents

Other manuals for IBM pSeries 630 6C4

Related product manuals