Checkpoint or Error
Code
What You Should Do
8xxx
9xxx
Axxx
Bxxx
Service Processor Checkpoints
Go to “Service Processor Checkpoints” on page 161 for more information on these
checkpoints.
A1FD 000x The system has entered recovery mode. Go to “Recovery Mode” on page 398.
B006 xxxx
B1xx xxxx
Common Firmware Error Codes
1. There may be additional error codes and information in the service processor error log.
The system must be powered off to examine the contents of the service processor error
log.
a. Is the system still powered on?
NO Go to step 2 below.
YES Ask the customer if the system can be powered off, then go to step 1b
below.
b. Can the system be powered off?
NO Go to step 3 below.
YES Power off the system, then go to step 2 below.
2. Confirm this is the first error code that caused the failure as described in “Confirming
Initial Error Code” on page 210.
3. Did you come to this step from step 2.
NO Go to “Common Firmware Error Codes” on page 335 with the error codes you
already have and follow the instructions in the Common Firmware error code
table.
YES Go to “Common Firmware Error Codes” on page 335 with the error code(s) from
step 2 and follow the instructions in the Common Firmware error code table.
Exxx Firmware Checkpoints
Go to “Firmware Checkpoints” on page 168 for more information on these checkpoints.
Mxxx xxxx Problem Determination-Generated Error Codes
Go to “Problem Determination Generated Error Codes” on page 351 and follow the
instructions in the Problem Determination Generated Error Codes table.
Chapter 5. Error Code to FRU Index 215
To Next Page
Loading...
Need help?
General