Table 2. SPCN Error Codes for the CEC (system unit) (continued)
Error Code Description Action/
Possible Failing FRU
1011 8409 No valid processor card VPD found
1. Verify that the processor card(s) is of the right
type for your system and is properly installed.
2. If only one processor card is installed, replace
it. If there are two processor cards installed,
remove the second processor card. If the
problem is resolved, replace that processor
card. If it does not resolve the problem, swap
the first processor card with the second, just
removed, processor card. If this resolves the
problem, replace the processor card that was
originally in the first slot. If it does not resolve
the problem, go to “MAP 1540: Problem
Isolation Procedures” on page 124.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
1011 840A VPD +5 stuck high Ignore all location codes.
Go to “MAP 1540: Problem Isolation Procedures”
on page 124 and run minimum configuration.
1011 840B VPD +5 stuck low Ignore all location codes.
Go to “MAP 1540: Problem Isolation Procedures”
on page 124 and run minimum configuration.
1011 840C Memory DIMM misplugged. Inspect system memory for proper installation of
memory DIMMs.
1011 840D SPCN configuration
1. Check cabling
2. Set the I/O type. See Power Control Network
Utilities Menu on page 380.
3. CEC backplane
Location: U0.1-P1
1011 840E SPCN default configuration loaded
1. Check cabling
2. Set the I/O type. See Power Control Network
Utilities Menu on page 380.
3. CEC backplane
Location: U0.1-P1
1011 840F I/O type not recognized
1. Check cabling
2. Set the I/O type. See Power Control Network
Utilities Menu on page 380.
3. CEC backplane
Location: U0.1-P1
1011 8413 Invalid processor 1 VPD Processor card
Location: U0.1-P1-C1
1011 8414 Invalid processor 2 VPD Processor card
Location: U0.1-P1-C2
1011 8423 No processor 1 VPD Processor card
Location: U0.1-P1-C1
1011 8424 No processor 2 VPD Processor card
Location: U0.1-P1-C2
Chapter 5. Error Code to FRU Index 221
To Next Page
Loading...
Need help?
General