Table 4. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
20FF00C0 Invalid VPD (missing base address of the
RIO-PCI bridge)
1. Replace the part specified by the location
code.
2. If no location code is shown with the error
code, call service support.
20FF00D0 Invalid VPD (machine type field is invalid)
1. Replace the part specified by the location
code.
2. If no location code is shown with the error
code, call service support.
20FF00F0 Invalid VPD (the rack number and the unit
number are not found in the SCF partition in
NVRAM)
1. Replace the part specified by the location
code.
2. If no location code is shown with the error
code, call service support.
2100 0xxx SCSI controller fault
1. Before replacing any system components,
refer to the notes in error code 21A00001.
2. Replace the SCSI device.
2101 0010 The IDE device remained busy longer than the
time-out period allows.
1. Retry the operation.
2. Check for system firmware updates.
3. Call service support.
2101 0011 Execution of the command by the IDE CD-ROM
was not completed within the allowed time.
1. Retry the operation.
2. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2101 0012 Execution of the ATA command by the IDE
CD-ROM failed.
1. Check the power and signal connectors
going to the IDE CD-ROM.
2. Retry the operation.
3. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2101 0013 Bootable media is missing from the IDE
CD-ROM.
Put a bootable CD in the IDE CD-ROM drive.
2101 0014 The media in the IDE CD-ROM drive has been
changed.
1. Retry the operation.
2. Check for system firmware updates.
3. Call service support.
2101 0015 Packed command execution by the IDE
CD-ROM failed.
1. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2. Check for system firmware updates.
3. Call service support.
Chapter 5. Error Code to FRU Index 237
To Next Page
Loading...
