Error Code Description Action/
Possible Failing FRU
B1xx 4643 I2C card/flex cable detection error
1. If the error code is B135 4643, it indicates a
PCI riser card detection error. Do the
following:
a. Verify that the PCI riser card (location:
U0.1-P2) is properly seated in the system
backplane.
b. Replace the PCI riser card, location:
U0.1-P2.
c. Replace the system backplane, location:
U0.1-P1.
2. For all other values of xx in B1xx 4643, go to
“MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4644 Processor VPD system fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4645 I2C (Non-processor) VPD System Fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4646 General VPD fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4647 Write TM field in system VPD Replace the operator panel, location: U0.1-L1.
Do not swap the VPD module from the old
operator panel onto the new operator panel;
leave the new, unprogrammed VPD module on
the new operator panel. Call service support for
instructions.
B1xx 4648 CPU Backplane VPD or Power Source Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4649 Power supply VPD failure CEC power supply
Location: U0.1-V1, U0.1-V2
B1xx 4650 A system processor failure has been detected by
the service processor. All system processors
have been reset in an attempt to recover
operations.
Information only. If the problem persists, check
the error logs for other fault indications.
If no other fault indications are found, go to
“MAP 1540: Problem Isolation Procedures” on
page 124.
B1xx 4651 CPU VPD fault Processor card
Location: U0.1-P1-C1, U0.1-P1-C2
B1xx 4660 Memory subsystem failure Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4661 Memory card VPD failure Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
B1xx 4662 Memory DIMM VPD failure Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
340 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
