11. From the bottom of the processor assembly, lift the side access cover. Four hinges hold the cover to
the top of the processor assembly. Pivot the cover up to reveal the memory DIMMs or DIMM
connectors.
12. Remove all memory DIMMs as described in “Memory DIMM Removal” on page 492. Put the DIMMs
in a safe place (you will need to install these DIMMs onto the new processor card).
Model 6C4 Processor Card
1 Service Access Cover 7 Model 6C4
2 Processor Access Cover 8 Optional Media Device (for example:
Diskette Drive or Tape Drive)
3 Processor Assembly Lifting and
Release Handles
9 IDE CD-ROM Drive
4 Processor Assembly 10 Front Bezel
5 Processor Card 11 Media Device Support Shelf
6 Memory DIMMs 12 Processor Filler
Chapter 9. Removal and Replacement Procedures 489
To Next Page
Loading...
