Chapter 10. Copy services 609
9. As shown in Figure 10-117, you can optionally select existing relationships to add to the
group. Click Next.
Figure 10-117 Select existing relationships to add to the group
10.In the window that is shown in Figure 10-120 on page 611, you can create relationships.
a. Select a volume in the Master drop-down list.
b. Then, select a volume in the Auxiliary drop-down list for this master.
c. Click Add.
Note: To select multiple relationships, hold down Ctrl and click the entries that you want
to include.
Note: When the first relationship is added to an empty group, the group takes on the
same state, primary (copy direction), type (Metro Mirror or Global Mirror), and
cycling mode as the relationship. Subsequent relationships must have the same
state, copy direction, and type as the group in order to be added to it. A relationship
can belong to only one consistency group.
To Next Page
Loading...
Need help?
General