Chapter 13. Encryption 783
1. Go to Settings → Security → Encryption, expand the USB Flash Drives section and
click Configure, as shown in Figure 13-57. Note that to enable USB flash drives as
a second provider, the system has to be able to access key servers with the current
master access key.
Figure 13-57 Enable USB flash drives as a second encryption key provider
2. After you click Configure, you will be presented with a wizard similar to described in
13.4.2, “Enabling encryption using USB flash drives” on page 761. Note that you will not
be given an option to disable SKLM provider during this process. After successful
completion of the process you will be presented with a message confirming that both
encryption key providers are enabled, as shown in Figure 13-58.
Figure 13-58 Confirmation of successful configuration of two encryption key providers
To Next Page
Loading...
Need help?
General