Starting the Human Interface Infrastructure (HII) Configuration
Application
Use these instructions to start the Human Interface Infrastructure (HII)
configuration utility program.
To start the Human Interface Infrastructure (HII) configuration utility program,
complete the following steps:
1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active after the power-on LED flashes slowly.
2. When prompted, <F1 Setup> is displayed, press F1. If you have set an
administrator password, you are prompted to type the password.
3. Under System Settings, select Storage.
When you have finished changing settings, press Esc to exit from the program;
select Save to save the settings that you have changed.
IBM Advanced Settings Utility program
The IBM Advanced Settings Utility (ASU) program is an alternative to the Setup
utility for modifying UEFI settings.
Use the ASU program online or out of band to modify UEFI settings from the
command line without the need to restart the system to access the Setup utility.
You can also use the ASU program to configure the optional remote presence
features or other IMM settings. The remote presence features provide enhanced
systems-management capabilities.
In addition, the ASU program provides limited settings for configuring the IPMI
function in the IMM through the command-line interface.
Use the command-line interface to issue setup commands. You can save any of the
settings as a file and run the file as a script. The ASU program supports scripting
environments through a batch-processing mode.
For more information and to download the ASU program, go to
http://www.ibm.com/support/entry/portal/docdisplay?lndocid=TOOL-ASU.
106 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General