v For PCI riser-card assembly 2:
a. Pull the release pin to unlock the retention latch; then rotate the retention
latch to the open position.
b. Carefully grasp the ServeRAID adapter by the edge and pull it out of PCI
riser-card assembly 2.
7. If you are instructed to return the ServeRAID adapter, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Note: When the ServeRAID adapter is removed, software RAID will not be
supported. This system does not support downgrade software RAID function
from hardware RAID configuration.
Replacing a ServeRAID adapter on the PCI riser-card assembly
Use this information to replace a ServeRAID adapter on the PCI riser-card
assembly.
About this task
Important: When you install ServeRAID adapters on the PCI riser-card assemblies,
please install them in the order listed:
v Slot 3
v Slot 2 (For the rear backplane or external ServeRAID adapter only)
v Slot 1 (For external ServeRAID adapter only)
Figure 102. ServeRAID adapter removal
Chapter 6. Removing and replacing components 191
To Next Page
Loading...
