Note: You must wait approximately 1 to 3 minutes after you connect the server
to a power source before the power-control button becomes active.
6. Start the Setup utility and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See “Using the Setup utility” on page 91 for details.
Removing the front USB connector assembly cable
About this task
To remove the front USB connector assembly cable that is on the side of the server,
complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 32.
2. Turn off the server (see “Turning off the server” on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Remove the server top cover (see “Removing the server top cover” on page
258).
4. Rotate the hot-swap rear hard disk drive cage up (see “Rotating the hot-swap
rear hard disk drive cage up” on page 168.
5. Remove the PCI riser-card assembly (see “Replacing a PCI riser-card
assembly” on page 208).
6. Remove the air baffle (see “Removing the air baffle” on page 261).
7. Make note of where the front USB connector assembly cable is attached to the
system board; then, disconnect it.
214 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General
