Replacing the hot-swap hard disk drive backplane
Use this information replace the hot-swap hard disk drive backplane.
About this task
To remove the hot-swap hard disk drive backplane, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 32.
2. Reconnect the power cable and signal cables that you removed from the
backplane.
Note:
a. Make sure that Port 1 on the hardware ServeRAID or system board is
connected to Port 1 on the backplane. Likewise, Port 0 on the hardware
ServeRAID or system board should be connected to Port 0 on the
backplane.
b. You can refer to the internal cable routing section “Internal cable routing”
on page 164 for further details.
3. Align the backplane with the slot on the chassis
4. Lower the backplane into the server. Leave the backplane an angle of
elevation so the backplane connectors will not get damaged. Make sure the
locating plates securely engages the bottom of the backplane.
5. Press the release latches; then, rotate the top of the backplane toward the front
of the server until it locks into place.
Figure 146. Power cable and signal cables
232 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General
