Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
General messages
80030012-2301xxxx Sensor OS RealTime
Mod has deasserted.
Info Indicate whether
the system
management
firmware is working
in the state to
support the
realtime OS.
No action; information only.
80070202-0701xxxx Sensor Planar Fault
has transitioned to
critical from a less
severe state.
Error A sensor has
changed to Critical
state from a less
severe state.
1. Check the system-event log.
2. Check for an error LED on the
system board.
3. Replace any failing device.
4. Check for a server firmware update.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
5. (Trained technician only) Replace
the system board (see “Removing
the system board” on page 290 and
“Installing the system board” on
page 292).
8007020f-2582xxxx Sensor No PCI I/O
has transitioned to
critical from a less
severe state.
Error A sensor has
transitioned to
critical from less
severe.
Complete the following steps for PCI
I/O resource error issue resolution:
1. Understand the I/O resource
requirements in a basic system.
2. Identify the I/O resource
requirements for desired add-in
adapters. For examples, PCI-X or
PCIe adapters.
3. Disable on-board devices that you
can do without and that request I/O.
4. In F1 setup, select the System
Settings → Device and I/O Ports
menu
5. Remove adapters or disable slots
until the I/O resource is less than
64 KB.
806f011b-0701xxxx The Front USB
connector has
encountered a
configuration error.
Error The system had
detected an
internal connection
error.
Reseat the front USB cable on the
system board.
806f011b-0701xxxx The Front Video
connector has
encountered a
configuration error.
Error The system had
detected an
internal connection
error.
Reseat the front video cable on the
system board.
Chapter 3. Diagnostics 87
To Next Page
Loading...
Need help?
General
