Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
806f0608-1301xx03 Power supply PS
Configuration error
with rating mismatch.
Error A power supply
configuration error
(rating mismatch)
has occurred.
1. Make sure that the power supplies
installed are with the same rating or
wattage.
2. Reinstall the power supplies with
the same rating or wattage.
806f0312-2201xxxx Entry to aux log has
asserted.
Info Entry to aux log
has been detected.
No action; information only.
80080128-2101xxxx Low security jumper
presence has
asserted.
Info The low security
jumper has been
detected.
No action; information only.
8008010f-2101xxxx Physical presence
jumper presence has
asserted.
Info The physical
presence jumper
has been detected.
No action; information only.
806f0028-2101xxxx TPM command fail
has asserted.
Error The TPM sensor
access has been
degraded or
unavailable.
1. Turn off the server and disconnect
the power cords. Reconnect the
power cords and restart the server.
2. If the problem remains, (trained
technician only) replace the system
board (see “Removing the system
board” on page 290 and “Installing
the system board” on page 292).
Firmware and software messages
806f000f-220103xx System encountered
firmware error -
unrecoverable boot
device failure.
Error A system firmware
error unrecoverable
boot device failure
has occurred.
This is a UEFI detected event. The
UEFI diagnostic code for this event can
be found in the logged IMM message
text. Please refer to the UEFI
diagnostic code in the "UEFI diagnostic
code" section of the Info Center for the
appropriate user response.
806f000f-220104xx System has
encountered a
motherboard failure.
Error A fatal
motherboard failure
in the system has
been detected.
This is a UEFI detected event. The
UEFI diagnostic code for this event can
be found in the logged IMM message
text. Please refer to the UEFI
diagnostic code in the "UEFI diagnostic
code" section of the Info Center for the
appropriate user response.
806f000f-220107xx System encountered
firmware error -
unrecoverable
keyboard failure.
Error A system firmware
error unrecoverable
keyboard failure
has occurred.
This is a UEFI detected event. The
UEFI diagnostic code for this event can
be found in the logged IMM message
text. Please refer to the UEFI
diagnostic code in the "UEFI diagnostic
code" section of the Info Center for the
appropriate user response.
Chapter 3. Diagnostics 89
To Next Page
Loading...
Need help?
General
