IBM System x3650 M4 Type 7915 - Page 113

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
4000000b-00000000 IP address of default
gateway modified
from %1 to %2 by
user %3s.
(%1 =
CIM_IPProtocolEndpoint.
GatewayIPv4Address;
%2 =
CIM_StaticIPAssignment
SettingData.
DefaultGatewayAddress;
%3 = user ID)
Info A user has
modified the
default gateway IP
address of the
IMM.
No action; information only.
4000000c-00000000 OS Watchdog
response %1 by %2.
(%1 = Enabled or
Disabled; %2 = user
ID)
Info A user has enabled
or disabled an OS
Watchdog.
No action; information only.
4000000d-00000000 DHCP[%1] failure, no
IP address assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
Info A DHCP server has
failed to assign an
IP address to the
IMM.
1. Make sure that the network cable is
connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the IMM.
4000000e-00000000 Remote Login
Successful. Login ID:
%1 from %2 at IP
address %3.
(%1 = user ID; %2 =
ValueMap(CIM_Protocol
Endpoint.
ProtocolIFType;
%3 = IP address,
xxx.xxx.xxx.xxx)
Info A user has
successfully logged
in to the IMM.
No action; information only.
4000000f-00000000 Attempting to %1
server %2 by user
%3.
(%1 = Power Up,
Power Down, Power
Cycle, or Reset; %2
=
IBM_ComputerSystem.
ElementName; %3 =
user ID)
Info A user has used
the IMM to perform
a power function
on the server.
No action; information only.
Chapter 3. Diagnostics 95